User guide

TALKSWITCH CONFIGURATION 49
Provisioning details
TalkSwitch SIP server
1. Select the This TalkSwitch location is the proxy/registrar checkbox. The page enables the
View Registrar Entries button. See Viewing registrar entries on page 53.
2. If the SIP server requires a non-default SIP server registration interval, SIP signalling port,
or starting RTP port, enter the new values. See VoIP Trunking on page 188.
3. Ensure your router is set up to perform port forwarding for the SIP signalling and RTP ports.
See Router port forwarding on page 36.
TalkSwitch SIP client
1. Leave the This TalkSwitch location is the proxy/registrar checkbox cleared.
The page disables the Registrar authentication list and the View Registrar Entries button.
2. Enter the Current public IP address or Fully qualified domain name (FQDN) of the SIP server
into the Proxy/registrar server name box.
If the SIP server requires a non-default SIP signalling port (i.e. if the SIP server cannot use
5060 as the SIP signalling port), specify the port number after a colon at the end of the
public IP address or FQDN (e.g. 123.45.67.89:3456).
3. Ensure your router is set up to perform port forwarding for the SIP signalling port. See
Router port forwarding on page 36.
The Provisioning Details area also allows you to view the status of registered SIP devices. See
Viewing registration status on page 54.
Authentication
The Authentication area allows you to set a username and password for the TalkSwitch VoIP
network if you choose to permit access exclusively to authorized devices.
1. If you are configuring the SIP server location, set Registrar authentication to Yes (digest).
2. Enter the User/account name. All SIP clients must use this name.
3. Enter the Password. All SIP clients must use this password.
System VoIP options
VoIP Caller ID
The VoIP Caller ID area allows you to set up the source for the caller ID name for outbound VoIP
calls. The same setting is used for the TalkSwitch profile and all service provider profiles.
Extension names are used by default.
1. Set the caller ID information for outgoing VoIP calls:
• To use the System name from the Administration page, select Use system name in caller
ID information for all outgoing VoIP calls.
• To use the First name and Last name from the Local Extensions/Fax page, select Use
extension names in caller ID information for all outgoing VoIP calls.
See Caller ID settings on page 65 to select the phone number that will appear on the
other phone.