User guide

TALKSWITCH CONFIGURATION 139
When Test Complete appears, click Close.
OPTIMIZED method
You will be prompted to terminate your TalkSwitch configuration session before launching the
TalkSwitch Line Optimizer program.
The TalkSwitch Line Optimizer should launch upon exit of the management software.
You can also launch this program from the start menu: Programs > TalkSwitch 6.12 > Line
Optimizer.
TalkSwitch Line Optimizer
The TalkSwitch Line Optimizer program automatically discovers TalkSwitch units on the same
LAN that your PC is connected to. Use the pull-down menu to select the unit you want to
optimize lines for. Click Connect.
You can also enter the IP address of the desired TalkSwitch unit in the IP field in the Explicit
Connection area. Specify the Port if necessary. The default port is 9393.
Use the checkboxes to select the line(s) you want to optimize for each unit, and click
Calibrate…
You will be prompted to allow a reboot of your TalkSwitch system. Click Yes.
The OPTIMIZED method requires that your PC and your TalkSwitch unit(s) be on the same LAN.
If Windows provides a security alert when launching the Line Optimizer program, click Ignore
or Unblock to proceed.