User guide

87Appendices
Appendix C - Quick Commandsand DTMF Functions
These DTMF Quick Commands can be dialed from a Local Extension or an outside
telephone at the Auto Attendant. To enter Command mode, dial at a Local
Extension or at the Auto Attendant. If you are requested to enter a password, enter
the Administrator password. Next, enter any command followed by the sign.
Command Action
30 TalkSwitch tells you which mode it is currently using
3x Switch Modes (x = 1or 2)
4x Record Auto Attendant (x = 1 to 9)
04x Erase Auto Attendant messages (x = 1 to 9)
5x Playback Auto Attendant messages (x = 1 to 9)
61 Record Auto Call Back Announced Message 1
62 Record Auto Call Back Announced Message 2
63 Record Auto Call Back Announced Message 3
64 Record Auto Call Back Announced Message 4
65 Record Prompted Call Back Announced Message
06x Erase Call Back Announced Message (x = 1 to 5)
71 Playback Auto Call Back Announced Message 1
72 Playback Auto Call Back Announced Message 2
73 Playback Auto Call Back Announced Message 3
74 Playback Auto Call Back Announced Message 4
75 Playback Prompted Call Back Announced Message
90 Set to Serial connection mode (default)
91 Set to USB connection mode
2xx 8<phone number> Enter Remote ext. (2xx) phone number
2xx 980 0 Enter Remote ext. (2xx) Turn off “Same Line Connect”
2xx 980 1 Enter Remote ext. (2xx) Turn on “Same Line Connect”
2xx 9 <Hunt Group> Enter Remote ext. (2xx) “Connect using:” Hunt Group
(Hunt Group = 9, 81-88)
1xx 61 Enable ‘Do not Disturb’ at the Local Extension
1xx 60 Disable ‘Do not Disturb’ at the Local Extension
TS-user manual_Final_3rd.qxd 8/9/01 2:15 PM Page 87