User guide

A D D I N G I P P H O N E S T O T A L K S W I T C H 4
Configuring the router manually
If you cannot access the router configuration through the IP Configuration page, configure the
router manually.
1. Open the router configuration and navigate to the screen used to set up port forwarding.
See your router documentation.
2. Map port 5060 (Type: UDP) to the TalkSwitch unit acting as local proxy. Port 5060 is the
default port for forwarding SIP signaling data to the TalkSwitch system.
If required, you can map a different port. In this case, enter the port in the SIP signalling
port box of the VoIP Settings window.
3. Map the following ports (Type: UDP) to the TalkSwitch units. These RTP ports forward voice
traffic to the TalkSwitch system by default.
If required, you can map different ports. In this case enter the first port in the Starting RTP
port box of the VoIP Settings window.
4. Map port 69 (Type: UDP) to the TalkSwitch unit acting as local proxy. Port 69 allows the
TalkSwitch system to configure external IP extensions.
5. Map port 8484 (Type: TCP) to the TalkSwitch unit acting as local proxy. Port 8484 allows the
TalkSwitch system to configure TalkSwitch IP phones as external IP extensions.
6. Map port 9393 (Type: TCP) to the TalkSwitch unit acting as local proxy. Port 9393 allows
remote configuration of the TalkSwitch system.
7. If available, enable Quality of Service (QoS) to give voice traffic priority over data.
Save the configuration to the router.
VoIP Lines/Unit Unit 1 Unit 2 Unit 3 Unit 4
4 6000–6006 6010–6016 6020–6026 6030–6036
8 6100–6114 6200–6214 6300–6314 6400–6414