User guide

A D D I N G I P P H O N E S T O T A L K S W I T C H 1 5
6. Use the keypad to enter the public IP address or FQDN of the TalkSwitch system, and then
press Set or Done.
7. Reboot the phone. After a short delay, the phone will indicate it is initializing the network,
checking for firmware updates, and following automatic programming steps. During this
process the phone contacts the TalkSwitch unit, which automatically registers and
configures the phone. When complete, the phone will display the extension name and
extension number. The phone is now ready for use.
If registration does not work
If the IP phone is not successfully registered and configured, perform the following steps. On
the phone:
1. Press the Options key.
2. Use the cursor keys to navigate to the Phone Status menu, and then press Enter or Show.
3. Use the cursor keys to navigate to the Restore Defaults menu, and then press Enter
or Show.
4. Enter the password. By default this is 22222. When the TalkSwitch unit configures the
phone, it changes the password to 23646 (which spells “admin” on the telephone keypad).
5. Use the cursor keys to navigate to the Factory Defaults menu, and then press Enter
or Show.
6. Select All Defaults, and then press Enter or Show.
7. If setting up an external IP extension, follow the steps in Programming the TalkSwitch IP
phone as an external IP extension after the phone reboots.
8. Contact your reseller or TalkSwitch Customer Support if registration is still unsuccessful.
Further configuration
The steps above will configure your TalkSwitch IP phone and will enable the programmable keys.
Click the Local Extension/Fax Help icons for instructions on configuring direct line access,
hunt group permissions, Caller ID settings (VoIP only), call handling, and voicemail.
For phone-specific configuration, refer to your phone user guide.
Contact your reseller or TalkSwitch Customer Support if you require further assistance with
special ports or network settings.