User guide

TALKSWITCH CONFIGURATION 73
1. Perform the notification process once:
When the unit detects the call was answered, it will play the notification
message once only, then discontinue any attempts to re-connect.
2. The unit continues to re-connect until the recipient presses or
and considers the notification attempt successful if the person at the
remote phone presses to skip listening to messages or to accept
the call and listen to messages.
This option is useful for cell phones where the cell phone company plays a
“subscriber not available” message instead of a busy tone. Once the cell
phone is answered, TalkSwitch prompts you to respond to the incoming
voicemail with or .
1. Click the checkbox next to Pager if you want to be notified by pager when
new messages arrive.
2. Enter the pager number as you would normally dial it from your
TalkSwitch location.
3. Enter the numeric message to be displayed on the pager.
Configure Notification Options (button)
Define how TalkSwitch dials out of your office when notifying you of a
voicemail. If the first connection is not successful, determine the number of
times TalkSwitch continues to attempt the connection.
When you choose to be notified by pager and remote phone, TalkSwitch
ensures that both locations have been contacted before finishing the
notification process.
Figure 63: Configure notification options