User guide

TALKSWITCH CONFIGURATION 59
the Caller ID of other local extensions. The person using that extension is
required to record her/his name for the directory.
For TalkSwitch VoIP calls, use:
Select the number you want to display at the remote location when VoIP
calls are placed from this extension. If Default VoIP number is selected, the
phone number associated with the outgoing VoIP port is used. This selection
makes the most sense if your VoIP numbers have been configured to handle
all inbound calls the same way.
For Service Provider VoIP calls, use:
Select the number you want to display at the remote location when VoIP
calls are placed from this extension through a service provider.
Figure 51: IP extension username and password
Phone Type
If you have a TalkSwitch phone connected to this extension, select the
model of phone from the pull-down menu. TalkSwitch uses this information
to configure the phone to support the features that match the capabilities of
the phone. Features include intercom paging, group paging over the
speaker, and message waiting counter on the TS-80, TS-200, TS-400 and
TS-600 phones.
If a name was not recorded before you set up the associated voice
mailbox, pick up the handset, press + <mailbox number> and
press 4.