User guide

TALKSWITCH CONFIGURATION 57
Configuring a local extension for use with a IP phone
1. Open the configuration software.
2. Select System Information -> Local Extensions.
3. Change the radio button from Regular Extension to IP Extension.
4. The default Username and Password are <user ext#> and <pass ext#>.
These are used to manage calls between TalkSwitch and the IP phone and
must match the username and password on the IP phone. Change only if
required.
Figure 49: IP extension
Once the phone has been programmed with the extension number,
username, password, registrar and proxy information you can confirm
registration as follows:
1. Connect the IP phone to the LAN with the Ethernet cable.
2. Connect the power to the IP phone.
3. Click the Refresh button when the phone indicates that it is registered.
Refer to the IP Phone Configuration Guide by clicking the link Start ->
TalkSwitch 4.10 -> Documentation -> IP Phone Guides -> Adding IP
Phones to TalkSwitch. If you are using a third-party IP phone, refer to
the user guide for that phone. You can also click the Purchase additional
IP entensions link at the bottom of the window (Figure 49) for
information and for entering an activation key.