User guide

44 TALKSWITCH USER GUIDE
• Ignore
• Reversals occur on Seizure and Release
• Reversals occur on Seizure and Answer
• Reversals occur on Answer and Release
Note that the default options for the specific country or region will be pre-
selected in the configuration software.
2.2.4 Line hunt groups
There are a total of 9 line hunt groups that control outbound call line
selections. These line hunt groups are used by local and remote extensions,
and by the call bridge feature. Each hunt group can support several line
choices and will attempt to use an available line in the order that they are
listed for that hunt group. Hunt group settings have no effect on incoming
calls.
Default setup:
1. Select System Information -> Line Hunt Groups.
2. Select a Line Hunt Group tab and enter a unique name in the Label field
to identify this group elsewhere in the configuration software.
3. Under Set Line Hunt Group, set the Line Type. If you wish to use this hunt
group to access telephone lines, select Phone Lines. To use this hunt
group to access VoIP numbers, select TalkSwitch VoIP Numbers, or Service
Provider VoIP Numbers, optionally.
For information about assigning and configuring the VoIP numbers in a
TalkSwitch or a servicer provider setting, see 5.4.3 VoIP Numbers on
page 176 and its subsections.
Hunt Group 9: selects any available telephone line.
Hunt Group 81: selects telephone Line 1.
Hunt Group 82: selects telephone Line 2.
Hunt Group 83: selects telephone Line 3 (four-line models only).
Hunt Group 84: selects telephone Line 4 (four-line models only).
Hunt Group 85 - 87: no lines assigned (by default)
Hunt Group 88: selects any available VoIP number (only applies
when a VoIP unit is present on the LAN).