User guide

TALKSWITCH CONFIGURATION 43
In the Phone numbers section
Enter the main telephone number for the incoming telephone line connected
to TalkSwitch. Enable the Distinctive Ring 1 and/or Distinctive Ring 2 if you
have this service on the current incoming telephone line and wish to have
incoming calls handled differently on the basis of the distinctive ring. If you
want distinctive ring numbers handled the same way as your Main number,
do not place a checkmark in the box.
If you checked the box, enter the distinctive ring telephone number for each
of the distinctive ring numbers associated with this incoming telephone line.
• Distinctive Ring 1 corresponds to any double ring pattern.
• Distinctive Ring 2 corresponds to any triple ring pattern.
1. Click the Activate line checkbox to enable the incoming telephone line
port.
2. Enter the normal telephone number for the incoming telephone line as
the Main number.
In the Telephone Company Services section
Check the boxes that correspond to telephone company services that are on
this incoming telephone line. Descriptions of these services and how your
unit deals with them are provided in Appendix B: TalkSwitch and Telephone
Company Calling Services on page 201.
Calibrate Lines (button):
Click this button whenever a line is added or changed. Calibrate Lines allows
TalkSwitch to optimize lines for call bridge and call forwarding. Only
incoming telephone lines that are detected get calibrated.
Click this button whenever a line is connected to equipment other than a
telephone company line, or if poor audio performance is encountered on the
line. Calibrate Lines allows TalkSwitch to optimize transmission performance
for the type of line or line equipment. The system’s defaults are set for local
telephone company lines, where the model of TalkSwitch is intended to be
used.
For information about assigning and configuring the VoIP numbers in a
TalkSwitch or a service provider setting, see 5.4.3 VoIP Numbers on page 168
and its subsections.
Reversal Signaling:
TalkSwitch supports Line Reversal options. Countries or regions utilizing this
supervisory signal will have the reversal signaling field on this screen and
have the ability to turn reversal detection on or off, as well as selecting one
of the four following options: