User guide

22 TALKSWITCH USER GUIDE
3. Power up and configure your units before adding any IP phones that will
be part of the system. It is important that you place the IP phones on the
same subnet as TalkSwitch.
Example: If your TalkSwitch unit has the IP address 192.168.1.200, your IP
phone should use IP addresses in the range 192.168.1.xxx that do not
conflict with other IP addresses.
Figure 24: Three units connected via a switch
1.10.2 Power up all the TalkSwitch units
Connect the provided AC adapters to each unit and plug the adapters into
available power outlets. Turn the units on by pressing the Power button on
the front of each unit. The lights on the front panels of the units will flash.
This means that they are powered up and connected to the LAN, but their ID
numbers are not set.
1.10.3 Setting or changing the unit ID
Units are shipped from the manufacturer with unit ID 1. If two or more units
are placed on the same LAN with the same unit ID number, it causes a
conflict. All the line lights on the front panel of the units are flashing. You
have to assign a different unit ID to each of the units.
1. Pick up a telephone handset connected to one of the extension jacks on
the unit and press to enter command mode.
2. Enter a password if prompted.
To change the unit ID, the configuration software must be closed!
LAN
MUSIC PA
E1 E2 E3 E4
E5 E6 E7 E8
L2 USB POWER
L4L3
L1
PF
LAN
MUSIC PA
E1 E2 E3 E4
E5 E6 E7 E8
L2 USB POWER
L4L3
L1
PF
LAN
MUSIC PA
E1 E2 E3 E4
E5 E6 E7 E8
L2 USB POWER
L4L3
L1
PF
1Internet 234
POWER
Reset