User guide

TALKSWITCH INSTALLATION 15
Restore Firmware (button)
This button is available as an alternate method to update firmware if an
update attempt has failed. Click the Restore Firmware button, then select
which firmware file to load onto the unit. The firmware update will then
begin. Follow the instructions presented at each step. Progress will be
displayed as the update proceeds.
If you are downgrading to an earlier firmware version, and have more than
one networked TalkSwitch unit, you must perform the Restore Firmware one
unit at a time, with the unit separated from the network during the restore.
For more information, see 1.5.2 Upgrading the TalkSwitch software and
firmware on page 5.
1.9 CONNECTING DEVICES
Move the unit(s) to a location where it can be attached to incoming
telephone lines and your telephone devices.
Figure 15: An example of residential wiring
1.9.1 Connecting incoming telephone lines
1. Choose a convenient wall jack to attach to your TalkSwitch and connect
your incoming telephone line(s).
When a unit is being configured, it is locked to prevent other computers
or persons using a phone from configuring changes at the same time. If
you leave the software open for longer than one hour, the unit unlocks
itself to allow configuration changes.
Advisory: In order to minimize disruption to your business, you may
want to configure TalkSwitch before connecting it to your incoming
telephone lines and extension phones.