User guide

208 TALKSWITCH USER GUIDE
Important Notices
CE Compliance
This equipment has been tested and found to comply with the following
standards:
EN55022:1998 + amendment A1:2000 + amendment A2:2003, Class B
EN55024:1998 + amendment A1:2001 + amendment A2:2003
EN60950-1:2001, first edition
EN61000-3-2:2000
EN61000-3-3:1995+ amendment A1:2001
CISPR22:1997 + amendment A1:2000 + amendment A2:2002
FCC and IC Warnings
This equipment complies with ACTA TIA/EIA/IS-968A and Part 68 of the
Federal Communications Commission (FCC) rules in the United States. It also
complies with regulations RSS210 and CS-03 of Industry Canada and Science
Canada. This equipment also complies with Part 15 of the FCC Rules, as well
as ICES003 of Industry Canada. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation of the device.
FCC Part 15
This equipment has been tested and found to comply with the limits for a
“CLASS B” Digital Device pursuant to Part 15 of the FCC rules. These limits
are designed to provide a reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with
these instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Call Redirection & Service Provider Billing Advisory
Use of the Automatic Route Selection, Toll Restriction and Call Detail
Recording features does not imply any guarantee whatsoever by
regulatory authorities, your telephone service provider(s), TalkSwitch or
its distributors and resellers, with regard to the accuracy of these
features and that the use of such a features may not be considered by a
telephone company in any disputes which may arise regarding the
accuracy of any subscriber's telephone account.
This equipment is marked with the CE symbol,
indicating compliance with CE standards.