User guide

VOIP INFORMATION 177
If needed, you can also add numbers outside of that range and access them
using hunt groups. You can assign these numbers when the 3-digit VoIP
numbers have already been assigned or reserved. To do this:
1. Under System Information -> VoIP Numbers, select an available VoIP
number and assign it to a unique number (i. e. 4004).
2. Select System Information -> Line Hunt Groups.
3. Ensure that you have at least one line hunt group configured (i.e. 88) to
Line Type: TalkSwitch VoIP Numbers.
4. Callers can now dial 88 from any extension to get a VoIP dial tone and
then enter 4004 to reach the VoIP location.
Figure 127: TalkSwitch profile in System Information
For VoIP calls made through a service provider, the service provider will
assign the VoIP numbers to be used for their service. To assist in assigning
VoIP numbers for your network, use the 5.6 VoIP network administration form
on page 186.
5.4.3.1 Assign VoIP phone numbers
TalkSwitch Profile section
All VoIP numbers are inactive when the system is first configured.