User guide

TALKSWITCH CONFIGURATION 107
a) Enter the telephone number where you would like TalkSwitch to call
you.
b) Record an announced message if required. Call back is activated right
after you initiate prompted call back and hang up. A small initial
long-distance charge is incurred at your current location when you
activate prompted call back.
Press on an analog phone or 55 on a IP set to enter
command mode. Enter the password if required.
Enter the command as listed below.
2.5.3 Call bridge
Call bridge allows you to use the TalkSwitch incoming telephone lines to
make outbound calls or transfers to local and remote office extensions. It
gives you access to your office-based long-distance savings plan from
anywhere around the world. You will first need to call into the unit from an
outside phone number .
Figure 98: Activating call bridge
How to use call bridge:
1. Call into the system from any out-of-office telephone.
2. At the auto attendant message, dial a hunt group you are authorized to
use (9 is default).
To record a message: 65
To play the message: 75
The call back number shown is always the last number the unit dials in
the last prompted call back session.