User guide

90 TALKSWITCH USER GUIDE
If 7 is dialed
TalkSwitch uses 7 to precede PBX extensions of another Centrex or PBX
system. If TalkSwitch is not connected to another system, 7 is inactive.
If 80–88, or 9 is dialed
If you press 80–88 or 9 at the auto attendant, you can access Call Bridge
if it has been enabled. See 2.5 Call Back/Call Bridge on page 102 for more
details about configuring call bridge and 3.11.1 Using call bridge on
page 152 for details on using call bridge.
2.4.3 Incoming telephone Lines
This section describes how TalkSwitch handles incoming calls based on the
incoming telephone line and distinctive ring numbers.
Configure incoming calls during mode 1, 2 and holiday mode
Each incoming telephone line has to be set to ring extensions and/or answer
incoming calls using one of the auto attendants. In this example, we will use
Auto Attendant 1 and Mode 1 to answer all incoming telephone lines. If you
are not using Mode 2 or Holiday Mode, you don‘t need to configure the
settings for those modes.
Figure 83: Call handling telephone lines
If you dial 6 at the auto attendant and Call Back is not enabled,
TalkSwitch answers with the prompt: “I am sorry, there is no matching
entry for these digits”.