User's Manual

CentraLite EMS
Operations, Maintenance & Service Manual
Page 29 of 31
The thermostat RAN will now be open for joining. This allows us to join the door and motion sensor(s) to
the thermostat.
Door sensors: remove the door sensor from the base. Be sure to default the sensor according to the
procedure on the next page. Then press the button three times. The LED on the door sensor should
begin to blink slowly. If it is successfully joined to the thermostat, then a message will appear on the stat
that says “Device Joined”. If it does not, then try the procedure again.
Motion sensors: remove the cover from the sensor. Be sure to default the sensor according to the
procedure on the next page. Then press the button three times. The LED on the motion sensor should
begin to blink slowly. If it is successfully joined to the thermostat, then a message will appear on the stat
that says “Device Joined”. If it does not, then try the procedure again. When finished, replace the cover
for the motion sensor.
Procedure for Defaulting Door and Motion Sensors
Remove the battery from the sensor.
While holding the button down firmly, reinsert the battery.
The LED will blink rapidly. When the LED stops blinking, release the button.
The sensor should now be factory defaulted and ready to be joined to a thermostat.