User's Manual

Centralite™ EMS Door Sensor

Instruction Bulletin

04/2010

Refer to the diagram for proper magnet and sensor alignment and orientation.

Do not exceed the maximum mounting distance between the magnet and the

sensor.

Figure 3: Mounting and Aligning the Door Sensor

KEY:

A. Magnet (Top view)

B. Alignment markers

C. Door sensor base (Inside view)

D. Screw provisions

E. Battery location

PROGRAMMING

Restoring Sensors to Factory Default State

Note: It is very important that the base and magnet line up correctly and be

within .5 in. (51 mm) when the door is closed.

The Door Sensor must be restored to the factory default state before capturing it

to the Room Area Network (RAN).

Follow the steps below to reset the Door Sensor to the factory default state.

1. Open the Door Sensor by pressing the access release tabs on the sides of

the sensor.

2. Remove and retain the battery (if installed).

3. Locate the Programming Button found on the center of the circuit board.

While pressing and holding the Programming Button, install the battery. The

LED will blink.

4. After the LED stops blinking, release the button. The Door Sensor is now

restored to the factory default state.

Capturing the Sensor to the Room Area Network (RAN)

1. With the thermostat Room Area Network (RAN) open for capturing, press the

Programming Button 3 times. The LED should begin to flash several times.

Verify that the sensor is successfully captured and indicated on the

thermostat.

2. Test the sensor using the thermostat diagnostic/test screen to make sure the

sensor is reporting accurate occupancy messages.

3. Replace the cover and verify that it is snapped fully onto the base.

Refer to the Centralite™ Energy Management System User's Guide for more

information on programming.