Operating instructions

Page 13For technical questions, please call 1-800-444-3353.SKU 97524
(58). Replace the Safety Cover, being
careful to line up the bolt holes and t
the Safety into the slot. Replace and
securely tighten all of the Safety Cover
Bolts (53). Make sure that the Safety
moves without sticking.
7. Reload the Nailer/Stapler.
8. Reconnect the Nailer/Stapler to the air
hose.
9. Press the Safety of the Nailer/Stapler
against an appropriate piece of scrap
wood.
10. Test fire the Nailer/Stapler several
times, checking for proper operation.
11. Disconnect the Nailer/Stapler, remove
the fasteners, and store the Nailer/
Stapler in a location out of children’s
reach.
12. If you are unable to clear the fastener
jam using the method prescribed above,
the tool should be taken to a qualied
service technician for proper servicing.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION, BEFORE ANY
MAINTENANCE OR REPAIRS
ARE DONE (including clearing
jams):
• Wear ANSI-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
impact safety goggles with side
shields.
• Release the trigger.
• Detach the air supply.
• Attempt to re the Tool into
a piece of scrap wood to
ensure that it is disconnected
and is incapable of ring any
fasteners.
• Empty the magazine and leave
it open during service. The
Magazine is spring-loaded
and may cause parts or a
fastener to y out of the Tool.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal noise,
vibration, or leaking air is
detected, have the problem
corrected before further use.