Specifications

300ml Cartridge Pusher 97631

The 300ml Cartridge Pusher has been designed for dispensing Loctite

adhesives from 300ml plastic cartridges.

The Cartridge Pusher is used in combination with a suitable Loctite

controller (97102, 97152 or 97153) and

dispensing valve (e.g. 97114).

A 300ml cartridge of a Loctite

adhesive is placed into the Cartridge Pusher and pressurised from a Loctite

controller.

The piston of the pneumatic cylinder pushes the product out of the cartridge, through a product feed line and to the

dispensing valve. The unit is therefore suitable for dispensing moisture curing adhesives. The Cartridge Pusher can be

pressurised automatically when the controller 97152 is switched on and depressurised when the controller is switched

off: An Empty signal is indicated by an LED lighting up and also appears as blinking text on the digital display of the

controller.

Depending on the type of adhesive involved, a rotor pump and drive unit can be connected to the Cartridge Pusher.

This is recommended for high viscosity and pasty materials. The complete assembly is operated via Loctite

controllers 97152 or 97153.

Technical Speciﬁ cations:

Optional: Can be upgraded with eccentric rotor pump for processing of high viscosity products

Air Input max. 4 bar (60 psi), ﬁ ltered to a

maximum of 30µm

Dimensions (W x H x D) 145 x 230 x 960mm

Weight 11.6kg

Features:

• Can be combined with Loctite

controller for dispensing high

viscosity products

• Integral Forward/backward/off

switch, allows operator to pre-set

piston control setup.

• Clampshell design for easy

and secure cartridge loading

and unloading

• Reed switch for low level

signalling