Specifications
G12
Parker Hannifin Corporation
Pneumatic Division
Richland, Michigan
www.parker.com/pneumatics
Flow
Controls
Integrated
Fittings
Sensing Control
Panel
G
Catalog 0600P-E
Module and Pre-Assembled Enclosure
A
B
P
S
3.28
(83,3)
.59
(15,1)
.25
(6,4)
7.09
(180.0)
2.76
(70.0)
8.84
(224,6)
3.41
(86,5)
1.13
(28,5)
.50
(12,7)
13.38
(339,7)
8.78
(223)
1.63
(40,1)
5/32" (4mm) Instant
Push-in Fitting (x2)
.25 Dia.
2 Places
Ø
(
6,35
)
Features
• The pre-assembled two-hand control enclosure
occupies both hands of an operator by requiring
nearly simultaneous operation of two pushbuttons
• Poppet – snap-acting (no spools)
• Same air as in cylinders – Filtration: 40 micron
• No lubrication required
PXPC111
WARNING
These devices should NOT be used in any application
involving rotary clutch presses. Two hand control
modules do not of themselves insure the safety
of any machine. Users and original equipment
manufacturers are responsible for making sure that
installations meet all relevant safety regulations.
!
General Characteristics
Operating Pressure .......................40 to 120 PSI (3 to 8 bar)
Permissible Fluids –
Air or neutral gas 40 micron filtration, lubricated or dry
Flow at 90 PSI (6 bar) ..................... 7 SCFM (200 l/mn ANR)
Operating Temperature ..........-5°F to 140°F (-15°C to 60°C)
Below 40°F (5°C), an air dryer is required
Storage Temperature ............ -40°F to 160°F (-40°C to 70°C)
Number of operations with dry air at 90 PSI (6 bar),
68°F (20°C), frequency 1 Hz .................. 1 Million Operations
Vibration resistance –
Conforms to section 19-2 of bureau Véritas regulations
(November 1987)
Materials –
Body ....................................................... Glass Filled Nylon
Operating Head ............................... Zinc Alloy and Plastic
Connections: ...................................................... 5/32" instant
Mounting
Approvals:
• In accordance with European Standard
EN 574 - September 1996
• Conforms to the model that has obtained CE Type
Test Certificate No. 02526 520 4631 0397
Dimensions
Inches (mm)
Operation
• Output “S” will appear only if “A” and “B” are
simultaneously operated (within .5 seconds or less of
each other).
• If the operator actuates only one pushbutton, either
“A” or “B”, or if both “A” and “B” are actuated but at an
interval greater than .5 seconds, output “S” will not
appear.
• Output “S” is regenerated by supply “P”. Output “S” will
therefore disappear if supply “P” is cut off.
• Output “S” will disappear if either “A” or “B” is released.
• If output “S” disappears for any reason, “A” and “B”
must be nearly simultaneously actuated to again
provide output “S”.
• Since output “S” is regenerated it appears sharply,
at full force (snap-acting), and is quickly exhausted
upon deactivation. In addition the module is not
affected by the length or diameter of tubing used for
output “S”.
Part Number Connections
PXPC111
5/32” Instant
Human / Machine Dialog
Two-Hand Controls
(Revised 03-23-13)