Specifications

SKU 92208 For technical questions, please call 1-800-444-3353. Page 4
21. Compressed air only. Never use combustible gas as a power source.
22. Use both hands. The torque generated from these tools can cause the tools to break
free of your grasp, causing serious injury and damage. Always operate the tools with
both hands.
23. WARNING: The brass components of this product contain lead, a chemical known to
the State of California to cause birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)
Note: Performance of the compressor (if powered by line voltage) may vary depending
on variations in local line voltage. Extension cord usage may also affect tool perfor-
mance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure all of the parts listed on pages 10-13 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover
of this manual as soon as possible.
Operation
Note: The directions below apply to both tools.
1. You will need to prepare a 1/4” air connector (not included) to connect to the Air Inlet on
back of the air tool’s handle. First, remove the plug from the Air Inlet. Then, wrap the
1/4” air connector with pipe thread seal tape before threading it into the Air Inlet.
Connect the 3/8” ID Air Source Hose (not included) to the tool.
Note: If you are not using an automatic oiler system, before operation, add a few drops of
Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour of
continual use.
2. Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended
air pressure of 90 PSI.
3. Check the air connection for leaks. Once you are satisfied there are no leaks, turn off
the air compressor and disconnect the tool.
For best service you should incorporate an oiler, regulator, and inline filter, as shown in
the diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
1/4”-NPT
Air Tool