Specifications

Page 7SKU 94605 For technical questions, please call 1-800-444-3353.
MAINTENANCE
1. After each use, remove the air hose and wipe the tool with a clean cloth
to remove any dirt and grease buildup.
2. To maintain tool life, always lubricate the air line by adding a few drops of
pneumatic tool oil to the air line before each use. Or, install the automatic
oiler-filter system as previously illustrated.
3. Before each use, drain water out of the air compressor tank and conden-
sation from the air lines. Refer to the Air Compressor Operator’s Manual.
TROUBLESHOOTING
Problem Probable Cause Possible Solution
Paint Shaker does not
tun on when Control
Valve (6) is opened.
1. Insufficient or no
air supply.
2. Problem or leak in
air hose.
1. Fill air tank or turn
compressor on.
2. Check air hose
connection.
Paint Shaker shakes
violently, abnormally.
1. Too much air pres-
sure.
2. Mounting hard-
ware loose.
1. Reduce pressure
to 45 PSI.
2. Tighten mounting
hardware.
07j