Specifications
PAGE 25
Toll Free 1.800.272.7764
Ink Data Sheets
PLT6 Data Sheet
Acrylic-based One- or Two-component Ink
Characteristics PLT6 ink is a single-component series ink that can also be used as a two-component
ink. This ink has a semi-glossy look and is quick to dry.
See on website Oeko-Tex® Standard 100 Certication for tagless textile label
printing.
Applications Particularly suited for printing on rubber, and natural or synthetic textile ber such as
leather and imitation leather as well as polyamide. Good results are also obtained on
polyurethane and polyamide.
Resistance Excellent mechanical and chemical resistance. If used as a two-component ink the
mechanical and chemical resistance is excellent and increases its adhesion.
Flash Point Above 43 degrees C.
Preparation Thin and mix well the PLT6 ink with PLTCAN Thinner in a portion of 10-20% max.
In warm climates and in the presence of ne details or screened images the use of
PLTD Retarder in a very small percentage is recommended. If the achievement of the
major mechanical or chemical resistance or a higher adhesion is required, the ink can
be used also as a two-component ink series. PLT6 can be mixed with hardener PLTH
in a ratio of 10 parts ink to 1 part hardener.
Pot Life The life of the mixed ink when used as a two-component ink is 8-10 hours after
which the mechanical-chemical resistance and adhesion decreases. This is
also dependent on room temperature and ratio of solvent.
An excessive dilution causes a loss of coverage, smudge and incomplete ink
detachment from the pad. A poor dilution may cause problems withdrawing ink
from the cliché obtaining a repetitive print quality and avoiding the "dripping"
of the same ink with lower print quality.
Drying & Hardening Generally the following drying times are applicable:
Hand drying at 68° F: Approx. 1-2 minutes
Drying time can be accelerated by using ovens with circulating hot air or spot devices
at high temperatures. The nal hardening of the ink is obtained after 24 hours.
Range of Colors PLT6 is available in 22 standard colors. Europa scale is available in transparent
colors. PLT6 has a high light fastness equivalent to 7-8 rating DIN fastness. PLT6 inks
are adjusted for printing with PLTCAN Fast Thinner, PLTA Thinner and PLTD Retarder
for printing ne detail.
Process Color Printing PLT6 inks are available in transparent colors PLT6 #180 Yellow, PLT6 #181 Magenta
and PLT6 #182 Cyan.
Clean-up PLTEBD recommended.
Storage PLT6 has a shelf life of about 2 years. Storage containers should be sealed and
placed in a cool dry place.
PLH hardener should not be stored for long periods. The cans should be closed im-
mediately after use, otherwise the hardener will become thick and useless.
Additives PLH Hardener
PLTCAN Thinner (This is different from other inks).
PLTA Thinner
PLTD Retarder