user manual

Page 4SKU 95583
For technical questions, please call 1-800-444-3353.
WARNING: The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive
harm). (California Health & Safety code § 25249.5, et seq.)
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Note: Performance of the compressor (if powered by line voltage) may vary de-
pending on variations in local line voltage. Extension cord usage may also affect tool
performance.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
SETUP
Recommended Air Line Components
Tire
Inflator
Air
For best service you should incorporate an regulator and inline filter, as shown in the
diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
You will need to prepare a
1
/
4
” air connector (not included) to connect to the Inlet on
the Tire Inflator. First, wrap the
1
/
4
” air connector with pipe thread seal tape before
threading it into the Inlet. Connect the
3
/
8
” ID Air Source Hose to a quick connect
coupler (not included), and then to the Tire Inflator.
Set the air pressure on the regulator to 174 PSI. Do not exceed the recommended
air pressure of 174 PSI.
Check the air connection for leaks. If leaks are present, disconnect from the air
source.
22.
23.
1.
2.
3.