Owner`s manual

INSERT MEMORY UPGRADE
1. Insert the module into the socket at approximately a 30 degree
angle. Note that the socket and module are both keyed, which
means the module can be installed one way only.
2. To seat the module into the socket, apply firm, even pressure to
each end of the module until you feel it slip down into the socket.
[When properly seated, the contact fingers on the edge of the
module will almost completely disappear inside the socket.]
3. With the module properly seated in the socket, rotate the module
downward, pressing until the clips at each end of the socket lock
into position. With most sockets, you will hear a distinctive CLICK,
indicating the module is correctly locked into position.
4. Once the module or modules have been installed, the computer's
cover can be reinstalled.
5. Reinstall the rechargeable battery pack and any cables
disconnected during the installation process.
6. Turn on the computer and follow the instructions in your computer
owner's manual that describe the steps necessary to allow your
computer to recognize the newly installed memory.
The installation of the memory upgrade may vary with each notebook
manufacturer. Please refer to your system manual for installation
instructions. Once you have installed your notebook memory upgrade,
it may be necessary to refer to your system manual for proper set-up
configuration instructions.