Operating instructions

Page 7SKU96959 For technical questions, please call 1-800-444-3353.
SET UP INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
Assembly
No assembly is required for this tool.
Mounting
This Self Level Laser has a mounting station for a tripod. Tripod is not included.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Tool set up
Note: Insure the Locking Device (13) is in the vertical position (OFF) before installing
batteries.
Remove Battery Cover (2).1.
Install batteries in Battery Case (4), making sure to align the batteries according 2.
to the indicated polarity.
Replace Battery Cover (2).3.
Use of a tripod (not included) is highly recommended. If tripod is not used, place 4.
the unit on a non-slip surface.
With the Locking Device (13) still in the vertical position (OFF), set the Self Level 5.
Laser on a solid surface that is as level as possible. Use Leveling Bubble (19)
on lower side of Housing to level by turning one of the Supporting Feet (18)
clockwise or counterclockwise. Adjust each of the three Supporting Feet (18)
until the Leveling Bubble (19) is as close to center as you can get it.
Rotating the Locking Device (13) lever to the horizontal position (ON) will release 6.
the hold on the laser heads and TURN ON the horizontal laser. The unit will
need 4 to 6 seconds to stabilize and will self adjust to +/- 3° bubble.
REV 08b