Owner's Manual
Page 4 For technical questions, please call 1-888-866-5797. Item 58978
SAFETY OPERATION MAINTENANCESETUP
6. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
Service
Have your Power Pack serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the Power Pack is maintained.
Power Pack Safety Warnings
1. Lead-acid batteries generate hydrogen gas when
charging. Hydrogen gas is explosive. Only use
the Jump-Start system in a well-ventilated area.
2. Jump Starting A Vehicle
a. Use the Power Pack for jump starting
a LEAD-ACID battery only.
b. For emergency use only. Do not use the Power
Pack as a replacement for a vehicle battery.
c. Be sure area around battery is well ventilated
while battery is being jump started.
d. NEVER jump start a frozen battery.
e. Do not attempt to jump start a vehicle with
a non-rechargeable or defective battery.
f. Study all battery manufacturer’s specific
precautions for jump starting.
g. DO NOT TOUCH POSITIVE AND NEGATIVE
BATTERY CLAMPS TOGETHER.
h. Unplug the Power Pack from its Adapter
before connecting its cables to a battery.
i. Connect and disconnect battery cable
clamps only after setting any Jump Starter
switches to OFF position.
j. Connect cables to proper polarities. Connect
black cable to negative body ground and
red cable to positive battery terminal.
k. Locate Power Pack as far away from
battery as battery cables permit.
3. Maintain labels and nameplates on the Power Pack.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
4. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE INSTRUCTIONS.
Specifications
Input 120 VAC, 60Hz, 0.4A
Cranking Amps 330A
Battery 9'&$K
Battery Cables Ǝ/
Maximum Air Pressure 250 PSI
Functions: 12 Volt Jump-Starter, Air Compressor,
9'&3RZHU6XSSO\DQG/(':RUN/LJKW