Use and Care Manual

Draw 4.25” diameter circle on your supplied lid. Carefully

cut out 4.25” hole in lid. Use 5/16” drill bit to drill bolt

holes.

Note: Use the Gasket for reference.

Turn Cyclone upside-down. Place Gasket on the base of the

Cyclone and align all the holes. Place the topside of the supplied

lid against Gasket and align all the holes. Secure Cyclone,

Gasket and lid together using four Bolts, and four Flange Nuts.

Note: Thoroughly tighten hardware to eliminate air leaks.

Put Cyclone and lid on top of your dust container and seal it

airtight.

Note: We recommend a drum or container that will withstand

the vacuum pressure, (at least a 90 mil side thickness), otherwise

the container may collapse when in use. The larger the

container, the sturdier the walls must be to prevent collapse.

Make sure there are no air leaks at the connections. Review for

common leak points.

Note: Any air leak in the lid or drum will affect separation

performance. Make sure to check your dust drum frequently so

you do not overfill it.