User guide

I 0206 - 6

4 - CONTROLS AND COMPONENTS

4.1 - BRAKE PEDAL

This pedal allows the operator to hold the wheel when tting the counterweights. It must not be actuated

during the measuring cycle.

4.2 - AUTOMATIC DISTANCE AND DIAMETER GAUGE

This gauge allows measurement of the distance of the wheel from the machine and the wheel diameter at

the point of application of the counterweight.

It also allows correct positioning of the counterweights on the inside by using the specic function (see

INDICATION OF EXACT CORRECTION WEIGHT POSITION) which allows reading, on the monitor, the position used

for the measurement within the rim (For calibration, see GAUGE CALIBRATION).

The gauge can only be used with the counterweight pincers mounted.

4.3 - AUTOMATIC WIDTH GAUGE (OPTIONAL)

Width gauging is through a SONAR device which measures the distance of the wheel without mechanical

contact, merely by closing the guard and each time a valid measurement has been made with gauge

DISTANCE AND DIAMETER GAUGE.

4.4 - AUTOMATIC WHEEL POSITIONING

At the end of the spin, the wheel is positioned according to the unbalance on the outside or else

according to the static unbalance (when selected).

Accuracy is +/-20 degrees.

Fig. 5