Specifications

3.EF.40.Rev. 1.0 8
Plug the power supply cord into a wall outlet (120Vac, 60Hz).The cord has a plug as shown at A.
An adapter as shown at C is available for connecting three-blade grounding-type plugs to
two-slot receptacles. The green grounding lug extending from the adapter must be connected to
a permanent ground such as a properly grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available. You should follow as shown at the below figure:
This appliance can be operated by both a remote control and a manual keypad. Once the unit has
been properly connected to an earthed electrical outlet, turn on the manual On/Off switch located on
the right hand side of the appliance (see below).
CAUTION! The unit’s power cord must be connected to a properly grounded and
protected 120V outlet. Always use ground fault protection where
required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you
suspect the unit is damaged, please call a qualified service technician to
inspect and to replace any part of the electrical system if necessary.
NOTE!
To use both remote and manual functions the manual on/off switch must be in the ‘ON’
position.
Fig. 6
Fig. 5
SECTION 4 GROUNDING
SECTION 5 OPERATING INSTRUCTIONS