User manual

RC200/203 Manual
www.celoxica.com Page 49
Parameters:
BaudRate: A code selecting the initial baud. Use the baud
codes set by
RC200RS232SetBaudRate().
Parity: A code selecting the initial parity. Use the parity
codes set by
RC200RS232SetParity().
FlowControl: A code selecting the initial flow control. Use
the flow codes set by
RC200RS232SetFlowControl().
ClockRate: Clock rate of the clock domain of the call to this
macro, in Hz.
Timing: Does not terminate in normal use.
Description:
Runs the device management tasks for RS-232 ports. Must
always be run in parallel with accesses to the device.
Selecting the baud
extern macro proc RC200RS232SetBaudRate (BaudRate);
Parameters: BaudRate: A code selecting the baud (see below).
Timing: 1 clock cycle.
Description:
Changes the baud of the RS232 interface.
BaudRate must be one of
the codes listed below.