User manual

PAL tutorial
DSM SIM MONITOR CONTENTS
2.2.5 Running the tutorial in hardware
The DSM FIR filter tutorial workspace is configured to automatically run Xilinx EDK and Place and Route
tools in a custom build step when you target the MicroBlaze processor on the RC200, RC200E or
Memec Design platform. You must have the Xilinx software installed for this to work.
You can run the application using a lowpass filter or a highpass filter (either low frequency or high
frequency waves are let through). To build a highpass filter, uncomment the line
//#define HIGHPASS
at the beginning the
dsm_fir.h header file. This file is shared between hardware and software side.
Targeting the RC200
To target the RC200/RC200E or RC300/RC300E you need a parallel cable (usb cable for RC300/E) to
download BIT files onto the board and a serial cable to download the software. The BIT file is
downloaded using Celoxica's FTU2 utility.
The description below assumes that you are targeting a standard or professional RC200/E board. If you
are targeting the expert version of the RC200, substitute references to RC200 for RC200E.
www.celoxica.com
Page 24