Installation Guide

window and door trim
Pediment and Urn Installation
(Fits Standard Size
Mantel Only)
Attach urn to pediment by sliding
urn into place from back. Fasten with
#8x1/2˝ self-tapping screws.
Measure 9-7/16˝ to each side of
the mantelcenter line and scribe a
vertical line approximately 8” long.
On each side of the lines, install
two clips. Be sure the bottom of
the bottom clip throats are located
at least 2-1/4˝ above the top of the
mantel and the top of the top clip
throat is no higher than 6-7/8˝ above
the top of the mantel. (Fig.1)
Position the pediment over the
mantel by inserting the three male
lugs on the bottom of the pediment
into the matching slots in the top of
the mantel.
Align the ribs over the clips and snap
into place.
Secure the top of the urn to the wall
by nailing through nail hole in urn.
(
Fig. 2)
With brick or stucco walls, caulk
space between top of pediment and
wall and other places where water
seepage is possible.
(Fig. 3)
9
7
/16"
9
7
/16"
No Less
Than 2
1
/4"
Above Top
of Mantel
No More
Than 6
7
/8"
Above Top
of Mantel
Fig. 2
Fig. 3
33