Installation Guide

leaf relief
83
leaf relief
Leaf Relief
®
Installation
(Mitered Corners)
Outside Corners
Use perforation pattern as a guide
to create corners. Using tin snips,
cut diagonally along the perforation
to create a 45° angle, starting at the
outside edge and cutting as shown,
through the plastic strip. Notch and
remove one inch of the front edge
and plastic strip from the newly
formed angle. When mounted, the
pieces will overlap one inch and form
a 90° outside corner. Place one screw
through the overlapping pieces.
Attach to back through plastic strip,
with screws, two inches from the
point of the corner.
TP53ZIP/TP63ZIP –
Inside Corner
NOTE: Because TP product has
profile, pre-fabricated corners can
not be used.
Use the perforated pattern to cut a 45°
angle at the ends of the Leaf Relief
sections. Then cut away 1 ˝ from the
front and back of one section as
shown.
The sections will overlap by 1 ˝ and be
attached with a #6x3/8 ˝ stainless
steel screw.
1" 1"
1" 1"
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5