WLC-100M Wireless ISA Module User’s Manual
FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. WLC-100M Wireless ISA Module complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
or transmitter This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users. For laptop installations, the antenna must be installed to ensure that the proper spacing is maintained in the event the users places the device in their lap during use (i.e.
device. Service Center in U.S.A Company Name : D-Link Corporation.
1. Introduction The WLC-100M Wireless module is the perfect solution for your wireless network applications based on the IEEE 802.11b standard offering a data rate of 11Mbps in a wireless LAN environment. WLC-100M is designed for Printer Server series, IP Camera series and Internet Video Server gives you wireless access the web and network resource without the wire.
2.412-2.484 GHz(Japan) 2.412-2.472 GHz(Europe ETSI) 2.457-2.462 GHz(Spain) 2.457-2.472 GHz(France) Number of Selectable USA, Canada: 11 channels Channels Europe: 13 channels Japan : 14 channels Data rate 1,2,5.
4.1.2.
4.2. Safety Recommendations The safety guidelines are as follows: Keep the board area clear and dust-free before, during, and after installation. Keep tools away from walk areas where you and others could fall over them. Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that could get caught in the board. Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
4.4. Installing a WLC-100M Remove the WLC-100M module from its protective packaging. Avoiding Electrostatic Discharge Before you install the WLC-100M module, ground yourself by touching a piece of metal to avoid electrostatic discharge (ESD). You should also take the following precautions to prevent damage to the WLC-100M module: Keep the WLC-100M module in its antistatic-shielded bag until you are ready to install it. Handle the WLC-100M module by its edges.
