User's Manual

Installing and starting the PS Admin program
PS Admin program can be conveniently used to configure and manage your
print server from any personal computer running the Windows operating
systems. Once the print server is configured, you can use it for printing from
any network environment.
If you use only the TCP/IP (U
NIX) and/or AppleTalk protocols and don’t
have a Windows system, you can use the telnet interface to configure your
print server (the default IP of print server is 192.168.0.1, the subnet mask is
255.255.255.0). For further information about using telnet interface, see
APPENDIX : TELNET INTERFACE ADMINISTRATION in PS
Admin program User’s Guide in your Print Server Installation CD .
The print server also supports web configuration permitting users to
configure settings through the web browser. Default IP address as follows:
♦ Default IP address – 192.168.0.1
♦ Subnet Mask – 255.255.255.0
Note:
The PC’s IP address must correspond with the print server’s IP address in the
same segment for the two devices to communicate. Please refer to the Web
Configuration of the Print Server section for further details.
Installing PS Admin Program
Follow the procedure outlined below to install PS Admin:
1. Insert the Print Server installation CD
2. Click Install PS Admin Program