User's Manual

If your application requires direct connection from an ADSL

modem through the Wireless Internet Camera’ s RJ-45 LAN port

and you also have an ISP PPPoE account. Click on “PPPoE”

option and enter the Service Name, User ID and Password into

the respective fields.

The Wireless Internet Camera will get an IP address from the ISP

each time the Wireless Internet Camera starts up.

Wireless Interface:

Connection Mode:

Use the Connection Mode to determine the type of wireless

communication for the Wireless Internet Camera. There are three

choices of Infrastructure mode, 802.11 Adhoc mode and

Adhoc mode. The default setting for the Connection Mode is

Infrastructure.

Note:

Keep in mind after setting the Wireless Interface make sure to

check the Slide Switch on the rear panel is positioned to either

LAN/WLAN or WLAN setting for the wireless communication to

take effect.

Network Name:

This field is used to setup which wireless network (ESS-ID

Extended Service Set ID) the Wireless Internet Camera is to be

connected for communication. The ESS-ID is a unique identifier

shared among all points in a wireless network environment.

The default Network Name is blank space (NULL String), this

default setting will let the Wireless Internet Camera connect to

ANY access point under the infrastructure network mode.