User's Manual

accessories that maintain a 10mm separation distance

between the user's body and the back of the handset. The use

of belt clips, holsters and similar accessories should not

contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not

comply with FCC RF exposure requirements, and should be

avoided.

Any Changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

FCC15.105 regulations

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.