Specifications

CellarMate Manual Page 7
Safety Considerations
When performing maintenance, always use the following Lockout/Tagout Procedure. More
than one power source may be present. Disconnect all power sources.
Lockout/Tagout Procedure
Turn power switch to OFF. Lights should be off.
Unplug unit from electrical outlet
WARNING
• Never reach into a unit while the fan is running.
• Never open an access door downstream of the fan while the fan is running.
• Do not expose the unit to rain or moisture.
• Check weight specifications to confirm that supports are adequate.
• Confirm that supports are designed to meet local codes and ordinances.
• Do not remove access panels until fan impellers have completely stopped.
Fan impellers continue to turn (free-wheel) after the power is turned off.
• Never pressurize equipment above the specified test pressure. (See
Specification Sheet)
• Do not operate near water.
• Do not block any supply or return air register.
• Do not modify or change polarized or grounding plugs. If the provided plug
does not fit into the outlet, consult an electrician for replacement of the
obsolete outlet.
• Only use attachments/accessories specified by the manufacturer.
• The CellarMate unit only operates on 120 VAC or 230 VAC, 1 phase 60Hz
power source.
• Always ground the outlet to provide adequate protection against voltage
surges and static charge build-up.
• Refer all service to qualified personnel.
• Do not place anything on top of the unit.
• Do not use extension cords.
• Use only dedicated power outlet boxes of the specified capacity and
configuration for the unit model.