Operating instructions

Voice mail access not working
Voice Mail access may have dialed the wrong number.
For this feature to work the voice mail number must be programmed for
the desired line. See section on IIVoice Mail".
How to check software version
To check the Cell2Tei C2T-XT2000 software version, connect a caller 10
enabled telephone to the telephone line jack on the back of the unit.
Simultaneously press and hold the Cell Phone Line 1 and Cell Phone
Line 2 Buttons for approximately 4 seconds. The phone connected to
the unit will ring and the phone's display will show the software version
information.
Pick up the ringing telephone's handset to stop the ringing.
FCC REQUIREMENTS
This Equipment complies with Part 68 of FCC rules and the
requirements adopted by the ACTA. On the bottom of this equipment
is a label that contains, among other information, a product identifier
in the format US:CACW400B301001. If requested, this number must
be provided to the telephone company.
The REN is used to determine the number of devices that may be
connected to a telephone line. Excessive RENs on a telephone line
may result in the devices not ringing in response to an incoming call.
In most but not all areas, the sum of the RENs should not exceed five
(5.0). To be certain of the number of devices that may be connected
to a line, as determined by the total RENs, contact the local
telephone company. [For products approved after July 23,2001, the
REN for this product is part of the product identifier that has the
format US:CACW400B301001.
The digits represented by 008 are
the REN without a decimal point (e.g., 038 is a REN of 0.3B). For
earlier products, the REN is separately shown on the label.]
Should
you experience trouble with this equipment, please visit
us at www.ceIl2telgateway.com for Customer Service
15