Operating instructions

VVhen dialing out using a cell phone connected to the Cell2Tel,an
optional [#] digit may be dialed at the end of the number to activate
immediate dialing, the same as the "Send" button on the cell phone.
Dialing a [#] is not required. The dialing process will start following a
short delay after the last digit is dialed.
After picking up a telephone connected to the Cel12Tel, you should hear
a steady dial tone, if you hear an error tone (series of rapid beeps),
there are no lines available for an outgoing call. In this case, check to
ensure that you have at least one cell phone paired and connected to
the Cell2Tei. If the telephone service line is in use, check that the line is
connected properly to the Cel12Tei .
Selecting a Line
If connected to the telephone service line (Iandline), the Cell2Tei will dial
out from the regular phone using the land line. You can choose to dial
out using a cell phone line by selecting the appropriate line that is paired
to the cell phone you wish to dial out on.
A specific line can be specified on a per call basis by first dialing the
desired line number and then pressing the Flash key on your telephone.
Example: To specify Cell Phone Line 2 for an outgoing call, dial
[2][Flash], then dial the intended phone number.
If Cel12Tei is not connected to the telephone service line, Cel12Tei uses the
lowest cell phone line number with a connected (paired) cell phone for
outgoing calls. For example, if cell phones for line 1 and 2 are
connected, all outgoing calls will be made on cell phone line 1.
Anytime a rapid series of beeps is heard instead of normal dial tone,
that specific cell phone line (or any cell phone line) is not available for
outgoing calls. This is because Cell2Tei has not been paired with a cell
phone or the cell phone is out of range.
9