User Guide
INSTALLATION - BRACKET MOUNT (sold-separately)
Ensure that triangle mark on the lens is aligned vertically.
2
Secure the LIGHTHEAD onto the BRACKET with a screw.
3
From the front, install the MOUNTING GROMMET
onto the BRACKET, and insert the LIGHTHEAD.
1
lighthead
mounting
grommet
Front side of
mounting bracket
Secure the BRACKET onto the desired mounting
surface with screws.
4
lens
screw
(M3 x 8mm)
Reversed side of
the mounting bracket
Mounting
Surface
screws
(#6 x 18mm)
Mounting
Surface
NOTE: Optical stripes must align
vertically to meet approved regulation.
WIRING 2 KITS TOGETHER
Below is a schematic diagram for wiring 2 kits together.
YELLOW wires from both controllers must be connected together for synchronization.
∙ If Mode 1 is selected: Head 1A&2A will flash alternately with Head 1B&2B.
∙ If Mode 2 is selected: All Heads will flash simultaneously.
NOTE: To have Head 1A&2B alternate with 1B&2A,
simply reverse the lighthead outlets on one of the
Controllers; (both kits must be in Mode 1).
* Refer to Flash Pattern Chart on the opposite page.
RED
YELLOW
BLACK
ON/OFF
12V@3A / 24V@2A FUSE
(user-supplied)
CHASSIS
GROUND
EXTENSION CABLE
to GND
BLACK
EXTENSION CABLE
to GND
Unit 1 Controller Unit 2 Controller
NOTE: The mounting area varies from vehicle to vehicle. (The diagram is not drawn to scale)
HEAD 1A
HEAD 1B
HEAD 2A
HEAD 2B