User Manual

For Simultaneous or Alternating Flash:
1. Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode; lighthead will
display short (single or double) flash:
• Single flash = Group1
• Double flash = Group2
2. Remove YELLOW wire from +VDC then momentarily apply +VDC to change Groups:
• Heads of the same Group will flash together.
• Heads of different Groups will flash alternately.
3. Save and Exit the Grouping Mode by powering off the lighthead.
USER MANUAL
LED FLUSH MOUNT KIT
151030UR03
WIRING
OPERATION
To +VDC (fuse @ 1A) ..................................... RED
To -Chassis Ground ................................... BLACK
For Synchronization and Flash Pattern......
YELLOW
Connect YELLOW wires of multiple lightheads together
for synchronization (All heads should be set at the same
Flash Pattern)
12~24VDC
1
2
3
4
5
6
7
FLASH PATTERNS
8
9
10
11
12
13
14
15
16
Single [2Hz]
Double [R65]
Triple [2Hz]
Quad [2Hz]
Random
Steady
Single [SAE] [CA13]
Mega [SAE]
Double [SAE]
Triple [SAE]
Quad [SAE]
Quint [SAE]
Ultra [SAE]
Single-Quad
Single H/L
Singe-Triple-Quint
For Flash Patterns:
Momentarily apply +VDC to YELLOW wire:
• once for next pattern
• quick three times for FP#1
NOTE: This unit may not be factory set at FP# 1.