User Manual

Bracket Mount* (sold-separately)
INSTALLATION
Pop-n-Lock
Select a mounting location and drill an 1.14” (29mm)
cut-out, and then install the LIGHTHEAD onto the
cut-out.
1
Lighthead
Ø29mm
Front side of
the mounting surface
NOTE: Optical stripes
must align vertically to
meet regulation.
Ensure that the optical stripes are aligned vertically.
2
lens
Front side of
the mounting surface
Where necessary, apply silicone around the reverse
side to prevent from rotating.
3
Reverse side of
the mounting surface
Silicone
(user supplied)
Ensure that the optical stripes are aligned vertically.
2
From the front, install the LIGHTHEAD onto the
BRACKET.
1
Lighthead
NOTE: Optical stripes
must align vertically to
meet regulation.
lens
SILICONE
SILICONE
Recommended Surface thickness @1.5~4.0mm
L-Bracket
L-Bracket
Where necessary, apply silicone around the reverse
side to prevent from rotating.
4
Silicone
(user supplied)
Mounting
surface
NOTE: To install more efficiently, use a rotating motion to
guide the LIGHTHEAD when installing onto the cut-out.
NOTE: To install more efficiently, use a rotating motion to
guide the LIGHTHEAD when installing onto the BRACKET.
SILICONE
SILICONE
Secure the BRACKET onto the desired mounting
surface with screws.
3
Screws (#6 x 18mm)
Torque Force: 4.9~5.9kgf-cm
Mounting
surface
Mounting
surface