Unit installation

OPERATION SECTION FOR HF-51/HF-70 & HFR-51 /HFR-70
R emote Control Operation
Up & down air flow direction adjustment
The up/down air flow direction can be adjusted by pressing the OUT FLAP button on
the remote control, each time this button is pressed, the vane angle changes in the
following sequence:
(1)
(2)
(3)
(5)
(AUTO)
(4)
• (1) through (5) are fixed positions.
• AUTO
oscillates up and down automatically.
Air flow velocity adjustment
To change the vane control velocity press the FAN SPEED button.
Each time the button is pressed, fan speed is changed in sequence,
[LO]
[MID]
[HI]
[AUTO]
To cool the whole room, use the
[HI] setting in COOL MODE. If the sound of the
air conditioner operating disturbs your sleep, use the SLEEP mode.
Recommended horizontal VANE range
In
AUTO mode the VANE positions are
adjusted automatically.
In
(1)
COOL or DRY mode VANE positions
or
(2)
are recommended.
In
HEAT mode VANE positions
(3)
or
(4)
(5) are recommended.
Horizontal & vertical auto swing
adjustment
Adjust the left to right air flow direction
with the remote control:
• Press the IN FLAP button, the air
swing fins will continually oscillate left
to right.
• Step through the diferent fins positions
using the IN FLAP button (fins can
also be set in a fixed position).
Note:
• In the cooling operation, when the air con-
ditioner is operated with OUT FLAP blowing
down (4) or (5) for 1 hour, the OUT FLAP
direction is automatically set to level to pre-
vent condensed water from dropping.
• Adjust the vertical OUT FLAP direction us-
ing the remote control.
• In heating operation, if the output air temper-
ature is too low or when defrosting is done,
the horizontal vane position is set to (1).
30