Unit installation

OPERATION SECTION FOR HF-25/HF-35 & HFR-25 /HFR-35
R emote Control Operation
Up/down air flow direction adjustment
The up/down air flow direction can be adjusted by pressing the VANE CONTROL button
on the remote control, each time this button is pressed, the vane angle changes in the
following sequence:
(1)
(5)
(AUTO)
(2)
(3)
(4)
• (1) through (5) are fixed positions.
• AUTO
oscillates up and down automatically.
Air flow velocity adjustment
To change the vane control velocity press the FAN SPEED button.
Each time the button is pressed, fan speed is changed in sequence,
[LO]
[MID]
[HI]
[AUTO]
To cool the whole room, use the
[HI] setting in COOL MODE. If the sound of the
air conditioner operating disturbs your sleep, use the SLEEP mode. (See next page)
Recommended horizontal VANE range
In
AUTO mode the VANE positions are
adjusted automatically.
In
(1)
COOL or DRY mode VANE positions
or
(2)
are recommended.
In
HEAT mode VANE positions
(3)
or
(5)
(4)
are recommended.
Note:
• In the cooling operation, when the air con-
ditioner is operated with VANE CONTROL
blowing down (4) or (5) for 1 hour, the
VANE CONTROL direction is automatically
set to level to prevent condensed water
from dropping.
• Adjust the vertical VANE CONTROL direc-
tion using the remote control.
• In heating operation, if the output air temper-
ature is too low or when defrosting is done,
the horizontal vane position is set to (1).
Left/right air flow direction adjustment
Adjust the air flow direction by hand,
move the air flow direction fins left/right to
direct the air as desired.
Swing adjustment (auto oscillation)
Press the SWING button, to adjust the air
swinging direction. Press the button again
to exit the SWING mode.
21