Unit installation

ManualsBrandsCeliera ManualsAir ConditionerDUCTLESS MINI SPLIT AIR CONDITIONING SYSTEMS

HARBOR POINT WALL SPLIT DUCTLESS SYSTEMS

OUTDOOR UNIT INSTALLATION

HEAT PUMP WIRING

If the system is a heat pump the defrost

sensor must be connected from the in-

door unit to the defrost sensor in the out-

door unit. Standard lead length is 25 ft,

if a longer length is required then cut the

lead and extend using thermostat wire.

The heat pump defrost sensor intercon-

nect wire comes bundled up with the indoor

units. It then should be “un-bundled” and

connected to the molex connection at the

indoor unit and run to the outdoor unit molex

connection, typically with the interconnect-

ing wiring and/or interconnecting tubing.

Note: use of colored wire (supplied with

line set) and defrost sensor connected

(heat pump only).

Indoor sensor connection

Outdoor sensor connection

Indoor

wire

connector

outdoor probe wire connector

for defrosting

Ground wires connected to the terminal plate on indoor and

outdoor units must be grounded.

Connection

of

wires

for

outdoor

unit

and

indoor

unit

(115V Models)

Outdoor

unit

�

Indoor

unit

To power

source

(heating model)

(208/230V Models)

Outdoor

unit

�

�

To

power

source

Indoor

unit

(heating model)

13

1

2

3

L3

L4

L1

L2

1

2

3

L3

L4

1

2

3

L1

N1

L

N

1

2

3

L1

N1

Defrost

Sensor