Instruction Manual

Fig. 12 Fig. 13

Now place the corner strip with suf cient tension on the narrow side of the

frame (Fig. 12) and  x the vertical side of the projection screen fabric to the

aluminium frame with the Velcro strips. Repeat the step on the opposite side

and stretch the projection screen surface as tightly as possible. (Fig. 13).

Depending on the weather, the fabric can be hard to correctly tension. In cold

weather, it is advisable to store the fabric in a warm room for 24 hours before

installation, so that it becomes more  exible and can be securely mounted. The

fabrics are cut precisely by laser and  t exactly on the frame.

The fabric is correctly  xed on the frame when the 4 corners lie exactly as

shown in  gs. 12 and 13, the  ap is folded neatly over and the short side of the

fabric covers it.

The fabric must be corrected in the Velcro area until it is absolutely  at over

the entire surface. To do this, the fabric must be pulled around the frame slight-

ly until it is done in such a way that there are no more creases on the surface.

If the fabric is correctly tensioned, the Velcro area of the fabric covers exactly

the Velcro area on the frame, or the surface is completely  at and the corners

of the fabric lie exactly on the corners of the frame.