Setup guide

WWW.CELESTRON.COM
ATTACHING NIGHTSCAPE TO TELESCOPE
Before attaching Nightscape to your telescope, remember to first power it down and
disconnect all cables. Nightscape has a 2” adapter with internal T-threads that
allows it to be attached in two ways:
Drawtube – Slide the 2” nosepiece adapter directly into your telescope’s 2” focuser
and secure using the thumb screws on the telescope.
T-thread – Thread your T-Adapter (sold separately) onto the 2” nosepiece or direct-
ly into the camera housing (with the 2” nosepiece removed). Attach the T-Adapter
securely to your telescope.
As the distance from the top of the nosepiece to the imaging sensor is the same
as the distance of a standard DSLR camera (55 mm), Celestron EdgeHD T-Adapters
provide the correct spacing for attaching Nightscape to an EdgeHD telescope. Model
#93644 (EdgeHD 8”) and #93646 (EdgeHD 9.25”, 11” and 14”).
CPC DLX EDGE HD (NOT INCLUDED)
NIGHTSCAPE ATTACHED
T-ADAPTER (NOT INCLUDED)
GUIDESCOPE (NOT INCLUDED)
FIGURE 4